Skip to content
Argyle Door SpecialistsRequest a visit
Open 24/7(249) 490-5342Call now
Technician in a mesh cap lifting the white cover of a ceiling opener while a red screwdriver points at the wiring inside. — Burnt River
Answering 24/7 in Burnt River

Garage Doors in Burnt RiverYou will knowbefore we start.

Call now · open 24/7(249) 490-5342

What's happening right now?

Door stuck open

Safely, right now

  1. Leave it where it stopped. Don't pull it down by hand or keep pressing the button.
  2. Keep the doorway clear of people, pets and vehicles.
  3. The red release cord stays untouched while the door is open, because the door can fall.
Call (249) 490-5342

Request a visit What the fix involves

Door won't close

Safely, right now

  1. Stop pressing the button. Trying again and again strains the opener and the top of the door.
  2. Keep clear of the doorway, even to move something out of the way. Tell us on the call if you can see anything in the door's path.
  3. Leave the safety sensors near the floor as they are: never tape them or bypass them.
Call (249) 490-5342

Request a visit What the fix involves

Spring snapped

Safely, right now

  1. Leave the door and the opener alone: no lifting it by hand, no pressing the button.
  2. Keep people, pets and cars clear of the door.
  3. The emergency release stays untouched while the door is up, because the door can come down.
Call (249) 490-5342

Request a visit What the fix involves

Car stuck inside

Safely, right now

  1. Don't drive into the door or try to force it open.
  2. If you heard a bang or the door feels heavy, don't pull the release or lift it. A spring may be broken.
  3. Arrange another way to get where you are going for now. The car can wait inside.
Call (249) 490-5342

Request a visit What the fix involves

Nobody in Burnt River should nod along to an explanation they did not follow. Before a tool comes out, the technician shows you the worn spring, the frayed cable or the stripped gear, tells you why it failed, and lays out the sensible choices side by side. The decision stays with you. We serve Baddow, Burys Green, Galena Hill and Silver Lake as well.

Request a visit

Same fees day or night · 21 years in business

The fix, explained · Burnt River

What is the door doing?

EmergencyTorsion Spring ReplacementOn a cold morning the remote does nothing useful: the light comes on, the motor turns briefly, the door stays shut.

The fix

Torsion spring replacement is really a service on the whole balance system. The spring sits on a shaft that turns in a centre bearing and two end bearings, drives a pair of cable drums, and lifts the door through two steel cables.

Until then

  1. When a spring breaks, the safe approach for the household is to leave the door where it is, keep people and vehicles clear, and avoid running the opener, which can damage the top section, the trolley or the gear drive.

  2. Pull the manual release only when the door is fully closed unless a technician asks otherwise; a door disconnected while partly open can move on its own if the springs are out of balance.

Call (249) 490-5342Request a visit Torsion Spring Replacement

EmergencyOff-Track Garage Door ResetThe rollers on the door have been squealing for months.

The fix

Winter produces a particular version of this call. Slush melts under the door during the day, freezes overnight and glues the bottom seal to the slab.

Until then

  1. Never run the opener on a door that is off its track or hanging crooked; every cycle drives the racked door harder into the rails and can pull the track from the wall or tear a hinge.

  2. Pull the manual release only when the door is fully closed unless a technician asks otherwise; a door disconnected while partly open can move on its own if the springs are out of balance.

Call (249) 490-5342Request a visit Off-Track Garage Door Reset

EmergencyGarage Door Cable ReplacementSomeone left the snow shovel leaning in the opening and the door came down on it.

The fix

Which counterbalance your door has shapes the job. Torsion doors carry a spring on a shaft above the opening, and the cables wind onto grooved drums at each end; the technician winds the spring down with steel bars, swaps the cables, sets the drums and winds it back up.

Until then

  1. Never run the opener on a door that is off its track or hanging crooked; every cycle drives the racked door harder into the rails and can pull the track from the wall or tear a hinge.

  2. Pull the manual release only when the door is fully closed unless a technician asks otherwise; a door disconnected while partly open can move on its own if the springs are out of balance.

Call (249) 490-5342Request a visit Garage Door Cable Replacement

EmergencyExtension Spring ReplacementThe home inspector's report on the house you are buying flags the garage door: extension springs with no safety cable running through them, coils…

The fix

What you have afterwards is a door that behaves like a much lighter object. Both corners leave the floor together, the door holds still when you stop it at waist height, and it settles onto the floor instead of slamming.

Until then

  1. When a spring breaks, the safe approach for the household is to leave the door where it is, keep people and vehicles clear, and avoid running the opener, which can damage the top section, the trolley or the gear drive.

  2. Pull the manual release only when the door is fully closed unless a technician asks otherwise; a door disconnected while partly open can move on its own if the springs are out of balance.

Call (249) 490-5342Request a visit Extension Spring Replacement

Book soonEmergency Release RepairAfter a week of lifting the door by hand you pressed the button, hoping it would catch.

The fix

The release only earns its keep on a door that behaves once it is free of the opener, so the visit starts with the door closed and a balance test rather than with the handle. Disconnected, a healthy door lifts with modest effort, holds around a metre off the floor and stays put at the top.

Until then

  1. Pull the release with the door fully closed whenever possible, and keep the opening clear as you do.

  2. Lift a door by its handles or the gripping points on the panel face, never at the joint between sections, which closes as the door bends around the track.

Call (249) 490-5342Request a visit Emergency Release Repair

Book soonGarage Door Opener Diagnosis and RepairThe door goes up perfectly.

The fix

What you get from the visit is more than a working door. You get told, in plain words, what was wrong and why it happened: a gear that had run dry for years, a sensor knocked out of line by a snow shovel, a wall control left in lock mode by a visiting grandchild.

Until then

  1. Pull the release with the door fully closed whenever possible, and keep the opening clear as you do.

  2. Never drive a vehicle at a closed door to get out; the door collapses and the stored tension in the counterbalance is released.

Call (249) 490-5342Request a visit Garage Door Opener Diagnosis and Repair

Ceiling-mounted garage-door opener with a red release cord, a blue stepladder below and a cordless drill on a workbench. — Burnt River
  • 21years in business
  • 24/7open, every day
  • Same feesday, night or weekend
  • On siteassessment preferred

Book a garage door visit in Burnt River.

When a garage door in Burnt River has stopped, the household is usually stuck too, so we organise the day around getting the door moving safely. The technician clears the fault, checks the rest of the door so the next part does not follow, and explains what he did before he drives away.

Kawartha Lakes, Trent Lakes, Argyle, Avery Point, Cameron, Kennedy Bay, Kinmount, Lorneville, Norland, Sandy Point and Victoria Road

  • You understand what we found. We point to the worn part, show what it should look like and explain what happens if it stays as it is.

  • Tools and parts kept tidy. Our kit stays in one spot, cables and springs are bagged as they come out, and nothing gets left behind.

  • More than one way forward. Repair the part, refresh the whole system, or start over with a new door: we explain each so you can choose confidently.

Send a few details about your door: (249) 490-5342

Sound familiar?

Burnt River

Pair of cast metal cable drums, two coiled steel cables, locking pliers, a combination wrench and red-handled cutters on a wooden bench. — Burnt River

1 / 10

The door lands with a thud you can feel through the kitchen floor, and sometimes it bounces back up a few centimetres before settling. The bottom section has a small dent where it keeps slamming the concrete.

Garage Door Tune-Up

Technician in a mesh cap driving a screw with a cordless drill into a roller bracket beside a curved metal track. — Burnt River

2 / 10

You pushed the slide bolt across like always, but tonight it stops short of the slot in the track and springs back. The door is down, the bottom seal is on the concrete, yet the bar and its hole are a finger's width apart.

Garage Door Manual Lock Repair

Technician in a mesh cap reaching a gloved hand to the curved door track beside a raised panel, with a pickup outside. — Burnt River

3 / 10

Backing out this morning, the mirror caught the track beside the door. Now there is a crease in the steel at about knee height, and the door stops with a bang every time a roller reaches it.

Garage Door Track Repair or Replacement

Technician kneeling at a white garage door, turning a screwdriver on a black handle latch mounted on a vertical steel strip. — Burnt River

4 / 10

The opener has started to groan on the way up. The door climbs slowly, hesitates near the top, and on the way down it sometimes stops a hand's width above the floor and reverses, as if something were in the way when nothing is.

Garage Door Balance Adjustment

Gloved hands using a wrench at the end of a black coiled spring, beside a black arm and a red-and-white pull rope. — Burnt River

5 / 10

You want the ceiling back. A storage loft, a vehicle lift or kayak racks would fit if the long rail and motor box were not hanging in the middle of the garage, and the low ceiling of an older house leaves little room for the standard rail anyway.

Garage Door Opener Replacement

Four long coiled garage-door springs on a concrete floor, three black with metal end cones and one rusty spring broken in two. — Burnt River

6 / 10

Since shelving went up along the garage wall, the door will not close and both sensor lights are dead. A screw or staple may have gone through the thin wire that runs from the opener to the sensors.

Photo-Eye Sensor Alignment or Replacement

A person kneels beside the side track and hinges of a closed sectional garage door. — Garage Door Safety Inspection, Burnt River

7 / 10

The new car has three buttons in the mirror for garage doors. You held the old remote up to it as the manual said, the light in the car changed, and yet the door ignores it completely. The handheld remote works fine.

Garage Door Remote and Keypad Programming

Person in a dark shirt standing before a closed cream sectional door, looking up at a coiled spring and red-tipped cord. — Off-Track Garage Door Reset, Burnt River

8 / 10

You like the brightness of clear glazing but not a direct view of everything stored inside. Frosted, tinted or obscure panels would let the new door share light while providing practical privacy.

Full-View Glass Garage Door Installation

Two people holding a dented lower garage-door section above a separate white panel resting on the ground. — Garage Door Panel Replacement, Burnt River

9 / 10

The rolling door starts upward, then one side rises ahead of the other. Its bottom bar sits on an angle, several slats scrape the guide, and the opening is no longer clear enough for normal shipping traffic.

Commercial Rolling Door Repair

Person fitting a black strip along the bottom edge of a partly raised garage door, with a cracked strip lying on the floor. — Garage Door Bottom Seal Replacement, Burnt River

10 / 10

The garage has a tall ceiling, yet the horizontal tracks sit much lower than the lights and joists. That unused wall height makes the open door feel like a low shelf across an otherwise generous room.

High-Lift Garage Door Conversion

Kawartha Lakes, Ontario

Burnt River information

Garage Door Remote and Keypad Programming, Garage Door Tune-Up, Garage Door Balance Adjustment, Photo-Eye Sensor Alignment or Replacement, High-Lift Garage Door Conversion, Garage Door Manual Lock Repair, Garage Door Opener Replacement, Commercial Rolling Door Repair, Garage Door Track Repair or Replacement and Full-View Glass Garage Door Installation

Town
Burnt River, Kawartha Lakes, Ontario
In business
21 years
Hours
Open 24/7 · nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

What the census means at the door

56%

Older homes. About 56% of homes in Kawartha Lakes were built in 1980 or earlier, according to the 2021 Census.

Where most houses were built a generation or more ago, a good share of garage doors are still the originals: wood or early steel sections on extension springs. Those doors respond well to fresh pulleys, safety cables and a careful balance, and the technician carries the parts for them.

84%

Mostly houses. Single-detached houses make up about 84% of homes in Kawartha Lakes (2021 Census).

Detached houses often have a room over the garage, a bedroom or an office, which makes the garage door part of the heated envelope. An insulated door, snug weatherstrip and a fresh bottom seal keep that room comfortable and the furnace from working overtime in winter.

Source: Statistics Canada, 2021 Census of Population

Open Burnt River in Google Maps

Before you book

Advice · (249) 490-5342

Which lubricant is right for a garage door?

A silicone-based or white lithium garage door lubricant, sold for the purpose. Penetrating oils and general sprays are thin, attract dust and are gone in weeks; heavy grease traps grit. For the rubber bottom seal and weatherstrip, use only a silicone spray, since petroleum products attack rubber and make it brittle. Nylon rollers with sealed bearings need no lubricant, while ones with an exposed bearing can need a touch where their own maker calls for it. A small amount on each point, worked in by moving the door, is enough.

Should the manual lock be removed when an opener is installed?

Opener makers ask for it to be disabled or removed, and the door industry's guidance agrees. Disabled can mean the bars are fixed back or taken out while the handle stays for appearance, or a snap latch is held open on its catch. Keeping a lock live for outages calls for a manufacturer-approved interlock, not a label alone, since a reminder and routine are not treated as a substitute for removing or disabling the bars.

Does a new piece of track have to match the rest of the set?

It does. Profile, gauge and radius all need to agree so a roller passes from old track to new without a step, and so both sides carry the door the same way. A two-inch track cannot mix with three-inch hardware, and a 12-inch curve beside a 15-inch one leaves the door meeting the horizontal run at two different heights. The technician measures the existing track and orders to it rather than to a general size.

How often does a garage door need a balance adjustment?

There is no fixed interval; the door tells you. Many doors go years between adjustments, especially when they are lubricated and the springs were sized correctly. A hand test each season is the reliable guide: if the released door holds at about a metre and stays fully open, it is fine. When it starts to drift or sink, that is the time.

Open 24/7

Request a visit

Book a garage door visit in Burnt River.

Call now · open 24/7(249) 490-5342
  • On-site assessment preferred
  • Same fees day, night or weekend
  • 21 years in business