Skip to content
Argyle Door SpecialistsRequest a visit
Open 24/7(249) 490-5342Call now
Person fitting a black strip along the bottom edge of a partly raised garage door, with a cracked strip lying on the floor. — Garage Door Bottom Seal Replacement, Kennedy Bay

Plan ahead Repairs · Kennedy Bay

Garage Door Bottom Seal Replacement in Kennedy Bay

Every mild afternoon the snow melts off the car, runs to the door, and by morning the rubber strip along the bottom is frozen to the concrete. Last week the opener lifted the door and left half the seal on the floor.

Call now · open 24/7(249) 490-5342

Request a visit

In plain words

What you have afterwards is a door that closes onto a single soft line of contact from jamb to jamb. Daylight under the door is much reduced, the draft across the floor eases, wind-blown leaves and snow are kept out more effectively, and the tighter gap makes the route in harder for mice. The opener has been reset so the door lands gently on the new strip instead of pressing it flat. You also leave knowing the seal's profile and size, which makes the next replacement a matter of one phone call, and a couple of simple habits for winter that keep the new seal from freezing to the floor.

Sound familiar?

One end of the bottom seal has slipped out of its channel and hangs down like a loose shoelace. Each time the door closes it folds under, each time it opens it flaps, and the gap beside it keeps growing.

How the visit goes

Garage Door Bottom Seal Replacement · Kennedy Bay

How the visit goes

Pair of cast metal cable drums, two coiled steel cables, locking pliers, a combination wrench and red-handled cutters on a wooden bench. — Kennedy Bay
  1. 1

    Which retainer and which profile

    Next the retainer along the bottom rail is identified. Most steel doors carry an aluminum extrusion with two channels that take the T-shaped or beaded edges of a U-shaped seal; some insulated doors have the channel moulded into a plastic bottom cap; older doors may have a single channel; wood doors often have a strip nailed straight to the rail. The technician measures the channel spacing and the T or bead size, checks the door width, and notes the height of the old strip. A seal chosen from these measurements slides in cleanly and holds, which is the difference between a replacement that lasts and one that works loose.

  2. 2

    Securing the door before work begins

    The opener's release cord is pulled so the motor is out of the picture, and the door is raised by hand to a height where the bottom rail sits at a comfortable working level, usually around chest height. A clamp goes on each vertical track just below a roller so the door cannot drift down while the retainer is exposed. The bottom brackets in each corner stay untouched throughout, because they carry cable tension whenever the springs are wound. With the door held and the floor in front clear, the seal and retainer can be handled like any other piece of hardware.

  3. 3

    Fewer visitors of the four-legged kind

    A continuous seal removes the easy route mice and insects used along the floor. If rodents were part of the reason for the visit, a few habits finish the job: keep birdseed, pet food and grass seed in lidded bins, move firewood and cardboard away from the walls, and check the jamb seals at floor level, where a gap beside the door is as inviting as one under it. Seals with a stainless mesh embedded in the vinyl are available for garages that have had repeated trouble. A sealed bottom edge plus tidy corners keeps the garage a place where nothing wants to nest.

In the van

  • Seal end caps
  • Aluminum bottom seal retainer
  • Bulb or U-style bottom seal
  • Silicone spray lubricant
  • Nail-on vinyl strip for wood doors

What affects the quote

  1. 1

    Door out of level

    If one corner of the door hangs low because of cable or spring tension, levelling the door is separate work done before the seal goes in and is priced on its own.

  2. 2

    Material chosen

    Standard vinyl, cold-flexible rubber and silicone are priced differently. Where the door faces the weather, the technician explains what the step up buys in flexibility and working life.

  3. 3

    Seal profile and size

    T-style, bead and bulb profiles in different widths and heights sit at different points on the parts list, and the retainer on your door decides which one is used.

Same fees day, night or weekend.

Have it ready

Before you call · 0 / 3

(249) 490-5342

Garage Door Bottom Seal Replacement: questions

Advice · (249) 490-5342

Can the seal be replaced in the middle of winter?

Yes, and winter is when most people notice they need one. Vinyl is stiffer in the cold, so the technician keeps the new roll warm until it is fed and takes a little longer working it across the channels. A seal frozen to the floor is freed by hand first. The door is then closed onto the new strip and the opener reset exactly as in summer, and the garage is sealed for the rest of the season.

Should I choose the tallest seal available?

Not as a rule. The seal should fill the measured gap with a little compression to spare. A profile far taller than the gap gets squashed flat, wears at the fold, bows the bottom section and can make the opener reverse. Where the floor dips at one end, a taller bulb is the right call for that door; where the floor is flat, a standard height lasts longer. Measuring first is what settles it.

Does a wood garage door use the same kind of seal?

Usually not. Wood doors most often carry a flat or angled strip of vinyl or rubber nailed directly to the bottom rail, rather than a profile that slides into a retainer. Replacement means removing the old strip and nails, checking the rail for soft or cupped wood, and fastening a new strip so its lip angles outward and meets the floor along the full width. A retainer can be added to a sound rail if you prefer a channel seal.

Kawartha Lakes, Ontario

Kennedy Bay information

Town
Kennedy Bay, Kawartha Lakes, Ontario
In business
21 years
Hours
Open 24/7 · nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

What the census means at the door

56%

Older homes. About 56% of homes in Kawartha Lakes were built in 1980 or earlier, according to the 2021 Census.

Original openers in older neighbourhoods often predate photo-eye sensors and rolling-code remotes. Bringing one up to date means a quieter motor, sensors that stop the door for a child or pet, and remotes that cannot be copied from the driveway, all installed in a single visit.

84%

Mostly houses. Single-detached houses make up about 84% of homes in Kawartha Lakes (2021 Census).

Single-detached homes give a technician room to work: a driveway for the van, side room beside the tracks and a clear header. That means spring replacement, opener installation and full door replacement can each be finished in one visit with the door properly secured throughout.

Source: Statistics Canada, 2021 Census of Population

Open Kennedy Bay in Google Maps

Open 24/7

Request a visit

Every mild afternoon the snow melts off the car, runs to the door, and by morning the rubber strip along the bottom is frozen to the concrete.

Call now · open 24/7(249) 490-5342
  • On-site assessment preferred
  • Same fees day, night or weekend
  • 21 years in business