Skip to content
Argyle Door SpecialistsRequest a visit
Open 24/7(249) 490-5342Call now
A person holding a clipboard examines the interior hardware of a closed garage door. — Garage Door Tune-Up, Kennedy Bay

Plan ahead Repairs · Kennedy Bay

Garage Door Tune-Up in Kennedy Bay

On windy nights the door rattles in its frame, there is a line of daylight along one side, and the bottom seal has gone hard and flat. Leaves and fine snow drift in underneath and the garage never seems to hold its temperature.

Call now · open 24/7(249) 490-5342

Request a visit

In plain words

The heart of a tune-up is the balance check. Your springs are meant to carry nearly the whole weight of the door so the opener only has to guide it. When the door is disconnected from the opener and lifted by hand, it should rise without effort, stay open on its own and hold still partway. A door that sinks or feels heavy is telling you the springs have lost tension, and an opener made to move a balanced door is straining. The tune-up identifies this and treats spring adjustment as its own carefully done job, with the door clamped and proper winding bars.

Sound familiar?

You pulled the red cord to lift the door by hand during a power cut and it felt like lifting a car. The opener has been doing all the work and grumbling about it, and you are not sure how long that can go on.

How the visit goes

Garage Door Tune-Up · Kennedy Bay

How the visit goes

Pair of cast metal cable drums, two coiled steel cables, locking pliers, a combination wrench and red-handled cutters on a wooden bench. — Kennedy Bay
  1. 1

    Watching one full cycle first

    Before a wrench comes out, the technician stands clear of the opening and runs the door all the way up and all the way down. They are listening and watching at the same time: where the squeal starts, whether the sections shake at a particular height, whether the door hesitates at the curve of the track, how it lands on the floor, and whether the opener labours or hums. Each observation is tied to a spot on the door or a point in the travel. That map guides the hands-on inspection that follows and gives a fair comparison at the end, when the same cycle is run again after the work.

  2. 2

    Setting travel and force on the opener

    The opener has two settings that drift over time: how far the door travels, and how much force it applies before deciding something is in the way. The technician runs the door and adjusts the down travel so the door seals firmly on the floor without bowing the top section or crushing the seal, and the up travel so it stops fully open without the trolley hitting the stop. Force is set as low as will reliably close the door, because a low force setting is what lets the door reverse gently on contact. On a sectional door the arm is kept from passing straight up and down at the closed position, which protects the top section and the rail.

  3. 3

    A door you hear less and trust more

    The most noticeable change is the sound. With the hinge pins and roller bearings lubricated and the loose hardware tightened, the squeal and the rattle that woke the household are gone or reduced to a low hum of rollers in a clean track. The door starts without the shudder and lands on the floor with a soft contact instead of a slam. Because the technician ran the same cycle before and after the work, you can hear the difference for yourself before they leave, and the sounds that remain, if any, are explained: what they are, which part they come from and whether that part is worth replacing now or watching for a season.

In the van

  • Photo-eye brackets and wire
  • Replacement hinges
  • Socket set and drivers
  • Silicone or lithium garage door lubricant
  • Replacement steel or nylon rollers

What affects the quote

  1. 1

    Track alignment

    Tightening track bolts is included. A track that has been pulled out of line or dented by a vehicle needs straightening or a section replaced, and that is quoted as its own repair.

  2. 2

    Type of opener

    Chain, belt, screw and wall-mounted jackshaft openers each have their own tension checks and lubrication points, and older units take longer to set for travel and force than newer ones.

  3. 3

    Number of doors

    Two or three doors on the same property are usually serviced in one visit, and the second and third door are quoted at a different rate from the first because the travel is shared.

Same fees day, night or weekend.

Have it ready

Before you call · 0 / 3

(249) 490-5342

Garage Door Tune-Up: questions

Advice · (249) 490-5342

What kind of doors and openers do you service?

Residential sectional doors of every common construction: steel, insulated steel, aluminum and glass, wood and composite, single and double width, with torsion springs above the header or extension springs beside the horizontal tracks. Openers of all the usual types are covered too, including chain drive, belt drive, screw drive and wall-mounted jackshaft units. If the door is a one-piece tilt-up or a commercial rolling door, mention that when booking so the right hardware comes along.

Which lubricant is right for a garage door?

A silicone-based or white lithium garage door lubricant, sold for the purpose. Penetrating oils and general sprays are thin, attract dust and are gone in weeks; heavy grease traps grit. For the rubber bottom seal and weatherstrip, use only a silicone spray, since petroleum products attack rubber and make it brittle. Nylon rollers with sealed bearings need no lubricant, while ones with an exposed bearing can need a touch where their own maker calls for it. A small amount on each point, worked in by moving the door, is enough.

My door has a lock bar. Should it be used with an opener?

Not while the opener is connected. If the slide lock is engaged and someone presses the remote, the opener pulls against a locked door and can bend the top section or strip its gear. On a door driven by an opener the lock is usually disabled or removed during a tune-up, and the opener's own hold on the door provides the security. If you want a manual lock for holidays, the technician can show you how to use it safely with the opener unplugged.

Kawartha Lakes, Ontario

Kennedy Bay information

Town
Kennedy Bay, Kawartha Lakes, Ontario
In business
21 years
Hours
Open 24/7 · nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

What the census means at the door

56%

Older homes. About 56% of homes in Kawartha Lakes were built in 1980 or earlier, according to the 2021 Census.

Original openers in older neighbourhoods often predate photo-eye sensors and rolling-code remotes. Bringing one up to date means a quieter motor, sensors that stop the door for a child or pet, and remotes that cannot be copied from the driveway, all installed in a single visit.

84%

Mostly houses. Single-detached houses make up about 84% of homes in Kawartha Lakes (2021 Census).

Single-detached homes give a technician room to work: a driveway for the van, side room beside the tracks and a clear header. That means spring replacement, opener installation and full door replacement can each be finished in one visit with the door properly secured throughout.

Source: Statistics Canada, 2021 Census of Population

Open Kennedy Bay in Google Maps

Open 24/7

Request a visit

On windy nights the door rattles in its frame, there is a line of daylight along one side, and the bottom seal has gone hard and flat.

Call now · open 24/7(249) 490-5342
  • On-site assessment preferred
  • Same fees day, night or weekend
  • 21 years in business