Skip to content
Argyle Door SpecialistsRequest a visit
Open 24/7(249) 490-5342Call now
Gloved person holding a black strip along the side of a sectional garage-door opening — Garage Door Perimeter Weatherstrip, Trent Lakes

Plan ahead Repairs · Trent Lakes

Garage Door Perimeter Weatherstrip in Trent Lakes

A length of weatherstrip along the right jamb has pulled away, nails and all, and it slaps against the trim every time the wind picks up. The wood behind it is dark and soft where it meets the floor.

Call now · open 24/7(249) 490-5342

Request a visit

In plain words

Around a garage door there are three seals: one on the bottom edge of the door, and two running up the sides and across the top of the opening. Those last two are the perimeter weatherstrip. They are fixed to the stop moulding on the jambs and header, and their flexible fin rests against the door face when it is closed, closing the gap between door and frame. Replacing them means fitting new lengths that meet the door evenly, cutting down how much wind, driven snow, dust, leaves and small animals get through. The bottom seal is handled as its own job, but the two are often done together.

Sound familiar?

The new door went in last year and looks perfect, but the old wooden stop and its tired seal were left in place. Along the top there is a gap you could slide a finger into, and the cold pours through it.

How the visit goes

Garage Door Perimeter Weatherstrip · Trent Lakes

How the visit goes

Pair of cast metal cable drums, two coiled steel cables, locking pliers, a combination wrench and red-handled cutters on a wooden bench. — Trent Lakes
  1. 1

    Measuring for the new pieces

    With the door closed, the header is measured across the full width of the opening and each side from header to floor, because openings are rarely the same on both sides. The profile is chosen to match the gap: a wider fin for a door that sits a little back from the stop, a narrower one where the gap is slight, and a one-piece stop where the wood is going. Colour is matched to the trim from a range of standard finishes. The technician also notes whether the existing stop projects far enough to cover the door edge, since a stop set too shallow leaves the fin working alone.

  2. 2

    Making the jamb sound

    Where probing found soft wood, it is dealt with before the seal. Rot at the base of the jamb is cut back to solid material and a matching piece of lumber or PVC trim is spliced in, fixed and primed. Minor soft spots are hardened with an epoxy consolidant and filled. Fasteners that will hold the new stop are then going into wood that grips them, which is what keeps the strip tight through years of the door pressing on it. Where the jamb is clad, the technician finds the solid framing behind the cladding and fastens through to it rather than into the thin skin.

  3. 3

    Slush, salt and the bottom of the jambs

    The lowest part of each jamb is where the weather does its work, so a little attention there protects the whole seal. Push slush away from the jambs when clearing the driveway rather than piling it against them, and rinse the salt off the bottom of the stop on a mild day. Keep the joint between the jamb and the sill caulked so meltwater runs off the face instead of behind it. If a section of jamb was replaced, keep its paint or PVC surface intact. A dry jamb base holds its fasteners, and fasteners that hold keep the seal tight.

In the van

  • Silicone spray lubricant
  • Jamb repair lumber or PVC trim
  • Epoxy consolidant and exterior primer
  • Exterior screws and weatherproof staples
  • Utility knife and mitre saw

What affects the quote

  1. 1

    Removing the old stop and paint build-up

    Lifting a wood stop that has been painted for decades, scraping old adhesive and knocking down paint ridges takes longer than pulling a loose fin, and the time shows in the quote.

  2. 2

    Commercial or oversized openings

    Wider and taller commercial doors often carry an aluminum retainer with a rubber insert or a brush seal, and the material and fitting time differ from a residential vinyl seal.

  3. 3

    Doing the bottom seal at the same time

    When the bottom seal on the door is also worn, renewing it during the same visit is offered as a separate line and saves the cost of a second call.

Same fees day, night or weekend.

Have it ready

Before you call · 0 / 3

(249) 490-5342

Garage Door Perimeter Weatherstrip: questions

Advice · (249) 490-5342

How is the seal fastened to the frame?

A flexible fin is nailed or stapled to the face of the wood stop with galvanized or stainless fasteners spaced evenly along its length; a one-piece vinyl stop is nailed or screwed through its rigid edge into the jamb and header. Fasteners go into sound wood, heads are set flush without crushing the vinyl, and the joint between stop and trim is caulked where water could get behind.

How long does perimeter weatherstrip usually last?

It depends on sun, cold and how the door meets it. One manufacturer's guide suggests replacing seals every two to three years, while a well-set fin kept free of paint and wiped with silicone before winter often goes considerably longer. Rather than a calendar, watch the fin: when it stiffens, cracks or shrinks back from the door, it has done its work.

The wood around my door is rotten near the floor. Can the seal still go on?

Yes, and the rot is handled first. The soft wood at the base of the jamb is cut back to sound material and a new piece of lumber or PVC trim is spliced in, fixed and primed, so the fasteners for the new stop bite into something solid. This is one of the most common additions to a perimeter seal job here, because slush and salt sit against the jamb base all winter.

Peterborough, Ontario

Trent Lakes information

Town
Trent Lakes, Peterborough, Ontario
In business
21 years
Hours
Open 24/7 · nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

What the census means at the door

47%

Homes of every age. About 47% of homes in Trent Lakes were built in 1980 or earlier, according to the 2021 Census.

A blend of older and newer homes usually means a blend of expectations too: keeping an original door running as long as sensible, or bringing a builder-grade door up to a quieter standard. Both are worthwhile, and the choice is explained at the door with the options side by side.

99%

Mostly houses. Single-detached houses make up about 99% of homes in Trent Lakes (2021 Census).

Detached houses often have a room over the garage, a bedroom or an office, which makes the garage door part of the heated envelope. An insulated door, snug weatherstrip and a fresh bottom seal keep that room comfortable and the furnace from working overtime in winter.

Source: Statistics Canada, 2021 Census of Population

Open Trent Lakes in Google Maps

Open 24/7

Request a visit

A length of weatherstrip along the right jamb has pulled away, nails and all, and it slaps against the trim every time the wind picks up.

Call now · open 24/7(249) 490-5342
  • On-site assessment preferred
  • Same fees day, night or weekend
  • 21 years in business